CPM 10V Steel

CPM 10V Steel

Steel name: CPM 10V
Table No.: 1763
Chemical composition in weight %: 2.45% C, 5.25% Cr, 1.30% Mo, 9.75% V
Steel group: PM tool steels
Properties: No data
Applications: Blanking dies, cold extrusion punches, forming dies, piercing dies, plastic mold dies, punches, shear blades, slitting cutters, trimming dies.
Reference: Not shown in this demo version.

Heat Treatment
Hardening: Air pressurized gas warm oil or salt. Sections less than 3" thick may be air cooled to maximum hardness. Sections 3" thick or more must be quenched at a faster rate using one of the methods below to attain maximum hardness. For pressurized gas, the furnace should have a minimum quench pressure of 4 bars. The quench rate to below 1000 °F is critical to obtain the desired properties. For oil, quench until black, about 900°F, then cool in still air to 150-125°F. For salt, maintained at 1000-1100°F, equalize in the salt, then cool in still air to 150-125°F.
Tempering: Temper immediately after quenching. Typical temperature range is 1000-1100°F. Do not temper below 1000°F. Hold at temperature for 2 hours then air cool to ambient temperature. Double tempering is required. Triple tempering is required when austenitized at 2100°F or higher.

Tempering Table

Price: 20.00 US $
Buy Online Tempering Diagram

Other Steel Data links
Carbides in Steel
CCT and TTT Diagrams of Steels
CCT and TTT Diagram Calculating Service
Hardenability Diagrams of Steels
Hardenability Calculating Service
Macro Defects in Steel
Metal Etchants
Non-Metallic Inclusions in Steel
Semiconductor Etchants

Disclaimer: The material data is a central depository of information based on global actual tests and calculated software data that is available to the public for a fee. The information and data presented herein are typical or average values and are not a guarantee of maximum or minimum values. Applications specifically suggested for material described herein are made solely for the purpose of illustration to enable the reader to make his own evaluation and are not intended as warranties, either express or implied, of fitness for these or other purposes. There is no representation that the recipient of this literature will receive updated editions as the become available.